Use this command to configure auto VoIP mode. The supported modes are protocol-based and oui-based. Protocol-based auto VoIP prioritizes the voice data based on the layer 4 port used for the voice session. OUI based auto VoIP prioritizes the phone traffic based on the known OUI of the phone.
When both modes are enabled, if the connected phone OUI is one of the configured OUI, then the voice data is prioritized using OUI Auto VoIP, otherwise protocol-based Auto VoIP is used to prioritize the voice data.
Active sessions are cleared if protocol-based auto VoIP is disabled on the port.
| Default | oui-based |
| Format | auto-voip [protocol-based | oui-based] |
| Mode |
|
Print
this page
Email this topic
Feedback
View PDF
Download EPUB