show spanning-tree vlan

This command displays spanning tree information per VLAN and also lists out the port roles and states along with port cost. The vlan-list parameter is a list of VLANs or VLAN-ranges separated by commas and with no embedded blank spaces. VLAN ranges are of the form “X-Y” where X and Y are valid VLAN identifiers and X< Y. The vlanid corresponds to an existing VLAN ID.

Format show spanning-tree vlan {vlanid | vlan-list}
Mode
  • Privileged EXEC
  • User EXEC

The following example shows CLI display output for the command.

(Extreme 220) (Routing) #show spanning-tree vlan 1
VLAN    1
          Spanning-tree enabled protocol rpvst
          RootID    Priority        32769
           Address         00:0C:29:D3:80:EA
           Cost            0
           Port            This switch is the root
           Hello Time 2 Sec Max Age 15 sec Forward Delay 15 sec
 BridgeID  Priority        32769 (priority 32768 sys-id-ext 1)
           Address         00:0C:29:D3:80:EA
           Hello Time 2 Sec Max Age 15 sec Forward Delay 15 sec
           Aging Time 300
Interface  Role        Sts            Cost         Prio.Nbr
---------  ----------  -------------  ---------    --------
1/0/1      Designated  Forwarding     3000        128.1
1/0/2      Designated  Forwarding     3000        128.2
1/0/3      Disabled    Disabled       3000        128.3
1/0/4      Designated  Forwarding     3000        128.4
1/0/5      Designated  Forwarding     3000        128.5
1/0/6      Designated  Forwarding     3000        128.6
1/0/7      Designated  Forwarding     3000        128.7
1/0/8      Designated  Forwarding     3000        128.8
0/1/1      Disabled    Disabled       3000        128.1026
0/1/2      Disabled    Disabled       3000        128.1027
0/1/3      Disabled    Disabled       3000        128.1028
0/1/4      Disabled    Disabled       3000        128.1029
0/1/5      Disabled    Disabled       3000        128.1030
0/1/6      Disabled    Disabled       3000        128.1031