Use this command to display summary information about remote devices that transmit current LLDP (Link Layer Discovery Protocol) data to the system. You can show information about LLDP remote data received on all ports or on a specific port.
Format | show lldp remote-device {unit/slot/port | all} |
Mode | Privileged EXEC |
Local Interface | The interface that received the LLDPDU from the remote device. |
RemID | An internal identifier to the switch to mark each remote device to the system. |
Chassis ID | The ID that is sent by a remote device as part of the LLDP message, it is usually a MAC address of the device. |
Port ID | The port number that transmitted the LLDPDU. |
System Name | The system name of the remote device. |
The following example shows CLI display output for the command.
(Extreme 220) #show lldp remote-device all
LLDP Remote Device Summary
Local
Interface RemID Chassis ID Port ID System Name
------- ------- -------------------- ------------------ ------------------
0/1
0/2
0/3
0/4
0/5
0/6
0/7 2 00:FC:E3:90:01:0F 00:FC:E3:90:01:11
0/7 3 00:FC:E3:90:01:0F 00:FC:E3:90:01:12
0/7 4 00:FC:E3:90:01:0F 00:FC:E3:90:01:13
0/7 5 00:FC:E3:90:01:0F 00:FC:E3:90:01:14
0/7 1 00:FC:E3:90:01:0F 00:FC:E3:90:03:11
0/7 6 00:FC:E3:90:01:0F 00:FC:E3:90:04:11
0/8
0/9
0/10
0/11
0/12
--More-- or (q)uit