Edit PIM Interface Parameters
Edit PIM parameters for an interface to customize the PIM configuration.
Before you begin
Before you change the state (active or passive) of a PIM interface, first disable PIM to prevent instability in the PIM operations, especially when neighbors exist or when the interface receives streams.
Procedure
- In the navigation pane, expand .
- Select PIM.
- Select the Interfaces tab.
- Configure the required parameters.
- Select Apply.
Interfaces Field Descriptions
Use the data in the following table to use the Interfaces tab.
|
Name |
Description |
|---|---|
|
IfIndex |
Shows the interface Index. This variable is a read-only field. |
|
Address |
Shows the IP address of the PIM interface. This variable is a read-only field. |
|
NetMask |
Shows the network mask for the IP address of the PIM interface. This variable is a read-only field. |
|
Mode |
Shows the configured mode of this interface. The valid modes are SSM and sparse. This variable is a read-only field. |
|
InterfaceType |
Specifies if the interface is active or passive. |
|
DR |
Shows the router with the highest IP address on a LAN designated to perform these tasks. |
|
HelloInterval |
Specifies how long to wait (in seconds) before the PIM router sends out the next hello message to neighboring switches. The default is 30 seconds. |
|
JoinPruneInterval |
Specifies how long to wait (in seconds) before the PIM router sends out the next join or prune message to its upstream neighbors. The default is 60 seconds. |
|
CBSRPreference |
Configures the preference for this local interface to become a C-BSR. The C-BSR with the highest BSR priority and address is the preferred BSR. The default is –1, which indicates that the current interface is not a C-BSR. |
|
OperState |
Indicates the status of PIM on this interface: Up or Down. |