Edit System Information

About this task

Edit system identification information, configuration file information, and perform system actions.

Procedure

  1. In the navigation pane, expand Configuration > Edit.
  2. Select Chassis.
  3. Select the System tab.
  4. Enter or edit the information as required.
  5. Select Apply.

System Field Descriptions

Use the data in the following table to use the System tab.

Name

Description

sysDescr

Shows the system assigned name and the software version.

sysUpTime

Shows the elapsed time since the system last started.

sysContact

Configures the contact information.

sysName

Configures the name of this device.

sysLocation

Configures the physical location of this device.

VirtualIpAddr

Configures the virtual IP address that the CPU advertises and stores in the switch configuration file.

VirtualNetMask

Configures the net mask of the virtual management IP address.

VirtualIpv6Addr

Specifies the virtual IPv6 address.

VirtualIpv6PrefixLength

Specifies the length of the virtual IPv6 address prefix (in bits).

DnsDomainName

Configures the default domain for querying the DNS server.

LastChange

Displays the time since the last configuration change.

LastVlanChange

Displays the time since the last VLAN change.

LastStatisticsReset

Displays the time since the statistics counters were last reset.

LastRunTimeConfigSave

Displays the last run-time configuration saved.

DefaultRuntimeConfigFileName

Displays the default Run-time configuration file directory name.

ConfigFileName

Specifies the name of a new configuration file.

ActionGroup1

Performs one of the following actions:

  • resetCounters— Resets all statistic counters.

  • saveRuntimeConfig— Saves the current run-time configuration.

  • loadLicense— Loads a software license file to enable features.

LicenseFileName

Specifies the name of the license file in the /intflash directory.

ActionGroup2

Specifies the following action:

resetlstStatCounters—Resets the IST statistic counters

ActionGroup3

Can be the following action:

  • flushIpRouteTbl—flushes IP routes from the routing table

ActionGroup4

Can be the following action:

  • softReset—resets the device without running power-on tests

  • resetConsole—resets the switch console

  • softResetCoreDump—reset with coredump

Result

Displays a message after you select Apply.

LocatorLED

Note:

Exception: only supported on VSP 4900 Series.

Configures the system Locator LED on or off. The default is off.