View the Remote DvR Database

Note

Note

This procedure only applies to the VSP 7400 Series.

Before you begin

Ensure that you enable DvR on the node.

About this task

Perform this procedure to view all remote DvR routes on a Controller or a Leaf node.

The Controller node displays all the IP subnet routes configured for that DvR domain. A Leaf node displays all IP subnet routes learned from the Controller(s) for the Layer 2 VSNs in the DvR Domain. It also displays the Host Routes (ARPs) learned from other DvR enabled nodes.

Procedure

  1. In the navigation pane, expand Configuration > Fabric.
  2. Select DVR Remote.
  3. Select the Database tab.
  4. Optional: To filter the rows based on the specific criteria, select Filter.

Database Field Descriptions

Use the data in the following table to use the Database tab.

Name

Description

DestIpAddrType

Specifies the address type of the IPv4 destination address of the DvR database entry.

DestIpAddr

Specifies the IPv4 destination address of the DvR database entry.

DestMask

Specifies the destination mask of the DvR database entry.

L3Isid

Specifies the Layer 3 I-SID of the DvR database entry.

EcmpIndex

Specifies the ECMP index for the DvR database entry.

NextHop

Specifies the MAC address of the next hop BEB, in the DvR database entry.

L2Isid

Specifies the Layer 2 I-SID of the DvR database entry.

VrfId

Specifies the VRF ID for the DvR database entry.

OutgoingInterface

Specifies the outgoing interface (port or MLT) of the DvR database entry.

SpbCost

Specifies the SPB cost of the DvR database entry.

PrefixCost

Specifies the prefix cost of the DvR database entry.

NextHopName

Specifies the host name of the next hop BEB, in the DvR database table entry.

Age

Specifies the uptime since creation of the DvR database table entry.