Configure a Management I-SID for Auto-sense Fabric Attach Proxy Switches

About this task

Perform the following procedure to configure a specific I-SID and customer VLAN ID to use as the management I-SID when a port is in the Auto-sense FA PROXY state.

The switch creates this I-SID dynamically and uses it instead of the onboarding I-SID.

Procedure

Enter Global Configuration mode:

enable

configure terminal
Configure the management I-SID:

auto-sense fa proxy management i-sid <1-15999999> c-vid <1-4094>

Variable Definitions

The following table defines parameters for the auto-sense fa proxy management command.


Variable	Value
c-vid `<1-4094>`	Specifies the customer VLAN ID.
i-sid `<1-15999999>`	Specifies the service instance identifier (I-SID).