ExtremeXOS Upgrade Process

Upgrading your ExtremeXOS image and modules uses the following process:

  1. Backup all configuration files (see Creating a Backup Configuration File).
  2. Download ExtremeXOS and module package images from the Extreme Networks support portal (see Downloading a New Image).
    Note

    Note

    Beginning with ExtremeXOS 16.1, there are two methods available for the upgrade process:
    • download url filename - provides a means of downloading multiple files at the same time over TFTP, HTTP, or anonymouns FTP.
    • download image filename - downloads a single .xos or .xmod file from a TFTP server.
  3. Place the image files on a server that your switch can locate (see Installing a Core Image).
  4. Discover your inactive partition (see Finding the Inactive Partition).
  5. Use the download image command to install each image on the inactive partition (see Installing a Core Image).
  6. Reboot the switch (see Reboot Options).

Upgrade Example

We recommend upgrading ExtremeXOS images and any modular packages at the same time. The following example shows the ExtremeXOS image summitX-15.7.1.4.xos being installed before rebooting the switch.

# show switch

SysName:          DUT1
SysLocation:
SysContact:       support@extremenetworks.com, +1 888 257 3000
System MAC:       00:04:96:97:D1:7B
System Type:      X460G2-48t-10G4

SysHealth check:  Enabled (Normal)
Recovery Mode:    All
System Watchdog:  Enabled

Current Time:     Wed Feb  8 17:48:45 2017
Timezone:         [Auto DST Disabled] GMT Offset: 0 minutes, name is UTC.
Boot Time:        Mon Feb  6 19:36:52 2017
Boot Count:       108
Next Reboot:      None scheduled
System UpTime:    1 day 22 hours 11 minutes 53 seconds

Current State:    OPERATIONAL
Image Selected:   primary
Image Booted:     primary
Primary ver:      22.2.0.43
Secondary ver:    22.2.0.41

Config Selected:  primary.cfg
Config Booted:    primary.cfg
Config Automatic: NONE

primary.cfg       Created by ExtremeXOS version 22.2.0.41
                  499811 bytes saved on Mon Feb  6 19:36:12 2017

# download image 10.68.9.7 summitX-15.7.1.4.xos primary
Debug information files are present in internal-memory.
These files will be removed if you continue with download.
Do you want to continue with download and remove existing files from internal-memory? (y/N) Yes
Do you want to install image after downloading? (y - yes, n - no, <cr> - cancel) Yes

Downloading to Switch....................................................................
Installing to primary partition!

Installing to Switch............................................................................
Image installed successfully
This image will be used only after rebooting the switch!

# reboot
Are you sure you want to reboot the switch? (y/N) Yes