Managing the Switch with Bluetooth Devices
You can manage the ExtremeSwitching X465 series switch using Bluetooth with mobile devices or laptops. Bluetooth is enabled by default.
Supported Platforms
Switch: ExtremeSwitching X465 series switch.
Adapters: Dongles with a common Bluetooth controller (Cypress CY20702). Vendors with CY20702 pluggable and CC&C (USB-BT-400).
Limitations
- Stacking with Bluetooth is not supported. Currently, access to a slot connected with a Bluetooth device is supported, but other slots cannot be accessed.
- No security procedures are initiated for Bluetooth connectivity.
- Only a specific list of Bluetooth dongles is supported.
- Only one Bluetooth adapter is enabled per card. Other adapters will be in powered off state.
Using Bluetooth
Bluetooth users/clients can access switches using either the global IP address or link local IP address. The Bluetooth interface is assigned with the global IP address (192.168.1.1/24 or 172.16.1.1/24). DHCP server runs on the Bluetooth interface. This is mainly to serve Bluetooth clients with DHCP support. After a Bluetooth connection is established, all Bluetooth clients are allocated IP addresses from this pool (192.168.1.2–192.168.1.20 or 172.16.1.1–172.16.1.20). For Bluetooth clients that do not support DHCP, you can use the link local IP address for accessing the switch. Range is 169.254.1.1–169.254.1.8.
- Insert a supported dongle into the USB port of the switch.
- If needed (Bluetooth is enabled by default), ensure that Bluetooth
capability, discovery, and pairing are all enabled. using the following
command:
enable switch bluetooth {discovery | pairing }
You can check Bluetooth status using the show switch bluetooth [statistics | inventory] command.
- If needed, enable Bluetooth on the desired Bluetooth device (phone or laptop).
- To initiate pairing, do one
of the following:
- Press and hold the mode button for approximately 5 seconds.
- Press the pairing button on the dongle.
The Bluetooth Status LED blinks green while pairing is in progress, and then becomes solid green when Bluetooth is connected.
Bluetooth Commands
To enable Bluetooth capabilities, use the following command:
enable switch bluetooth {discovery | pairing }
To disable Bluetooth capabilities, use the following command:
disable switch bluetooth {discovery | pairing }
To clear Bluetooth devices, use the following command:
clear switch bluetooth device [all | address]
To show Bluetooth information, use the following command:
show switch bluetooth [statistics | inventory]