Auto-provisioning Configuration
-
Auto provisioning is enabled by default. It can be
restarted by clearing the switches configuration using unconfigure switch {all | erase [all | nvram]} with the
all and rebooting the switch.
Note
Auto provisioning is not enabled on the VLAN (Mgmt or Default) if the IP address is already configured. -
To disable auto provision, use the following
command:
disable auto-provision
When the disable auto-provision command is issued, the following message is displayed:
This setting will take effect at the next reboot of this switch. -
To display the current state of auto provision on the
switch, use the following command:
show auto-provision