IXP MPLS Enhancements
 
 
  ExtremeXOS Release 15.4 adds the following IXP 
MPLS feature enhancements:
    - EMS logs reflect the operation status changes of LSPs, PWs, and
     Interfaces.
- Show command displays details for transit and egress RSVP-TE LSPs.
- Metaswitch fixpack enhances logging of PATH failures.
- RSVP-TE description field now displays LSP Name/Path.
- MPLS commands are added to “show tech-support” functionality.
- Add support for the Metaswitch dmptrace facility.
 
  EMS Logging of MPLS Protocols, LSPs, PWs, and Interfaces
   
   The following EMS logs allow you to track MPLS protocols, some LSPs, and PW
    and MPLS I/F operational states. These logs are added at the “Info” level, and are not generated
    in the default log output (the default level for MPLS is “Warning”).
   LSPs
    
     - MPLS.ChgStaticIngrLSPState
- MPLS.ChgStaticTrnstLSPState
- MPLS.ChgStaticEgrLSPState
- MPLS.RSVPTE.ChgIngrLSPState
 
   
   MPLS Protocol Interfaces
    
     - MPLS.ChgIfState
- MPLS.ChgProtoState
- MPLS.LDP.ChgProtoState
- MPLS.RSVPTE.ChgProtoState
 
  
  Enhanced Show Details for Transit and Egress RSVP-TE LSPs
   
   The following fields are added to the 
show mpls rsvp-te lsp
    command output on transit and egress nodes:
     - Administrative & Operational Statuses
- Setup & Hold Priorities
Enhance Usability and Ability to Debug MPLS
   
   
    - Apply fixpack to provide better debugging for RSVP-TE Path message
     handling
- Use RSVP-TE “Tunnel Description” field in MPLS TE MIB to indicate LSP
     and PathBecause primary and secondary RSVP-TE LSPs use the same LSP name,
     and the idea of Redundant LSPs is an EXOS feature, determining which path is associated with an
     LSP could only be done through the CLI. To eliminate this problem, the RSVP-TE “Tunnel
     Description” MIB field (RFC 3812: mplsTunnelDescr) now returns the “LSPName (PathName) on the
     Ingress node.    Note    The tunnel description is not signaled as part
     of RSVP messaging, so this information is not available at transit and egress nodes. 
- Add MPLS (including RSVP-TE) debug information to show
      tech-support mpls command.
- Add support for the Metaswitch dmptrace
     facility