ERPS Version 1 Commands
-
To create or delete an ERPS
ring, use the following commands:
create erps ring-name {ring-id ring_id}
delete erps ring-name
-
To add or delete a control VLAN on the ERPS ring, use the following commands:
configure erps ring-name add control {vlan} vlan_name
configure erps ring-name delete control {vlan} vlan_name
-
To add or delete a protected VLAN on the ERPS ring, use
the following commands:
configure erps ring-name add protected {vlan} vlan_name
configure erps ring-name delete protected {vlan} vlan_name
-
To add ring ports on the ERPS ring (this ring's ports connect the switch to the ERPS
ring), use the following command:
configure erps ring-name ring-ports [east | west] port
-
To add ring ports on the ERPS ring, use the following
command:
configure erps ring-name ring-ports [east | west] port
-
To configure CFM for ERPS ring ports, use the following command:
configure erps ring_name cfm port [east | west] [add | delete] group group_name
-
To delete ring ports on the ERPS ring, use the following
command:
unconfigure erps ring-name ring-ports west
-
To add or delete RPL (ring protection link) owner
configuration for the ERPS ring, use the following commands:
configure erps ring-name protection-port port
unconfigure erps ring-name protection-port
-
To add or delete RPL (ring protection link) neighbor
configuration for the ERPS ring, use the following commands:
configure erps ring-name neighbor-port port
unconfigure erps ring-name neighbor-port
-
To add or delete ERPS revert operation along with the
wait-to-restore time interval, use the following commands:
configure {erps} ring-name revert [ enable | disable ]
-
To configure the periodic timer, use the following
command:
configure {erps} ring-name timer periodic [ default | milliseconds ]
-
To configure the guard timer, use the following
command:
configure {erps} ring-name timer guard [ default | milliseconds ]
-
To configure the hold-off timer, use the following
command:
configure {erps} ring-name timer hold-off [ default | milliseconds ]
-
To configure the wait-to-restore timer, use the following
command:
configure {erps} ring-name timer wait-to-restore [ default | milliseconds ]
-
To rename the ERPS ring/sub-ring, use the following
command:
configure erps old-ring-name name new-ring-name
-
To enable or disable ERPS, use the following
commands:
enable erps
disable erps
-
To enable or disable an existing ERPS ring/sub-ring, , use
the following command:
enable erps ring-name
disable erps ring-name
-
Run or clear force and manual switch triggers, or clear
command to the ERPS ring/sub-ring.
configure erps ring-name dynamic-state [force-switch | manual-switch | clear]