ERPS Version 2 Commands
-
To set the rings to which to propagate topology change
events, use the following command:
configure erps ring-name [add | delete] topology-change ring-list
-
To enable or disable the ability of ERPS to allow the topology-change bit to be set (to send out Flush events), ,
use the following commands:
enable erps ring-name topology-change
disable erps ring-name topology-change
-
To add or delete a sub-ring to the main ring, use the
following command:
configure {erps} ring-name [add | delete] sub-ring-name sub_ring
-
To configure the wait-to-block timer, use the following
command:
configure {erps} ring-name timer wait-to-block [ default | milliseconds]
-
To add or delete an ERPS sub-ring to the EAPS domain, use the following commands:
configure {erps} ring-name notify-topology-change {eaps} domain_name
unconfigure {erps} ring-name notify-topology-change {eaps} domain_name
-
To configure a wait-to-block timer, use the following
command:
configure {erps} ring-name timer wait-to-block [ default | milliseconds]
-
To configure sub-ring mode, use the following
command:
configure erps ring_name subring-mode [no-virtualChannel | virtualChannel]
Note
If the ERPS configuration of RPL owner node is modified, you need to disable, and then enable, corresponding ERPS instance on all non-RPL nodes. -
To configure R-APS control MAC as either auto or default, use the following
command:
configure erps ring-name control-mac [auto | default]