Network Login MAC-Based VLANs Rules and Restrictions
This section summarizes the rules and restrictions for configuring network login MAC-based VLANss:
- You must configure and enable network login on the switch and before
you configure network login MAC-based VLANs.
If you attempt to configure the port‘s mode of operation before enabling network login, the switch displays an error message similar to the following:
ERROR: The following ports do not have NetLogin enabled; 1
- If you attempt to configure network login MAC-based VLANs on 10
Gigabit Ethernet ports, the switch displays an error message similar to the
following:
ERROR: The following ports do not support the MAC-Based VLAN mode; 1, 2, 10
In ExtremeXOS version 12.0 and later, you can configure MAC-based-VLANs on 10 Gigabit Ethernet ports.
- You can have a maximum of 1,024 MAC addresses per switch.