Configuring an Egress QoS Profile
-
Egress QoS profile rate
shaping is disabled by default on all ports. On all platforms, use the following commands
to configure egress QoS profile rate shaping on one or more ports:
configure qosprofile egress qosprofile [{minbw minbw_number} {maxbw maxbw_number} | {peak_rate peak_bps [K | M]}] [ports [port_list | all]]configure qosprofile qosprofile [{minbw minbw_number} {maxbw maxbw_number} | {{committed_rate committed_bps [K | M]} {peak_rate peak_bps [K | M]} | [ports [port_list | all]]configure {qosprofile} qosprofile [[{maxbuffer buffer_percentage} {use-strict-priority}] | [maxbuffer buffer_percentage ports [port_list | all]]]
Note
You must use these commands on all platforms if you want to configure the buffer size or weight value. Otherwise, you can use the command in the following description.
You cannot configure the priority for the QoS profile.
- To remove the limit on egress bandwidth per QoS profile per port, re-issue this command using the default values.
-
To display the current configuration for the QoS
profile, use the following command.
show qosprofile [ all | port_list | port_group]