Enabling and Disabling MPLS on an LSR

To enable MPLS on an LSR, use the following command:
enable mpls

Note
For SummitStacks, see the ExtremeXOS 32.2 Command Reference Guide description for the enable mpls command for special requirements for SummitStacks.

By default, MPLS is disabled on the switch. This command starts the MPLS process, allowing MPLS protocols to run and MPLS packets to be forwarded.
To disable MPLS on an LSR, use the following command:
disable mpls

When you disable MPLS, LDP and RSVP-TE are effectively disabled. The MPLS configuration remains intact.