Configuring Target Addresses
-
To configure a target address, use the following
command:
configure snmpv3 add target-addr [[hex hex_addr_name] | addr_name] param [[hex hex_param_name] |param_name ] ipaddress [ ip_address | ipv4-with-mask ip_and_tmask ] | [ ipv6_address | ipv6-with-mask ipv6_and_tmask ]] {transport-port port_number} {from [src_ip_address | src_ipv6_address]} {vr vr_name} {tag-list [tag_list | hex hex_tag_list]} {volatile}
In configuring the target address you supply an address name that identifies the target address, a parameters name that indicates the MP model and security for the messages sent to that target address, and the IP address and port for the receiver. The parameters name also is used to indicate the filter profile used for notifications.
The from option sets the source IP address in the notification packets.
The tag-list option allows you to associate a list of tags with the target address. The tag defaultNotify is set by default.
-
To display target addresses, use the following
command:
show snmpv3 target-addr {[[hex hex_addr_name] | addr_name]}
-
To delete a single target address or all target addresses,
use the following command:
configure snmpv3 delete target-addr [{[[hex hex_addr_name] | addr_name]} | all]