Configuring EVPN
To configure EVPN:
- Configure underlay L3 network (see BGP and OSPF).
- Configure tenant VLANs and virtual-networks (see VXLAN).
- Enable L2VPN-EVPN capability (see Sending/Receiving Routes).
- If manual route targets (RTs) are
required (see Applying Manual Route Targets to EVPN Instances):
- Create EVPN instances.
- Configure EVPN instances.
- If eBGP is used, set next-hop-unchanged for L2VPN-EVPN routes (see Enabling/disabling Next-Hop Unchanged Behavior).

Note
BGP Auto-peering (see BGP Auto-peering) automates most of the above steps. If you are using BGP Auto-peering, only Step 2 and configuring LTEP IP are required