Display Port PoE Status

To display the PoE status per port, run the show inline-power info {detail} ports {port_list} command. This command provides the following information:

  • State—Displays the port power state:
    • Disabled
    • Searching
    • Delivering
    • Faulted
    • Disconnected
    • Other
    • Denied
  • PD‘s power class—Displays the class type of the connected PD:
    • “-----”: disabled or searching
    • “class0”: class 0 device
    • “class1”: class 1 device
    • “class2”: class 2 device
    • “class3”: class 3 device
    • “class4”: class 4 device
    • “class5”: class 5 device
    • “class6”: class 6 device
    • “class7”: class 7 device
    • “class8”: class 8 device
  • Volts—Displays the measured voltage. A value from 0 to 2 is valid for ports that are in a searching or discovered state.
  • Curr—Displays the measured current, in milliamperes, drawn by the PD.
  • Power—Displays the measured power, in watts, supplied to the PD.
  • Fault—Displays the fault value:
    • None
    • UV/OV fault
    • UV/OV spike
    • Over current
    • Overload
    • Undefined
    • Underload
    • HW fault
    • Discovery resistance fail
    • Operator limit violation
    • Disconnect
    • Discovery resistance, A2D failure
    • Classify, A2D failure
    • Sample, A2D failure
    • Device fault, A2D failure
    • Force on error
The detail command option lists all inline power information for the selected ports. Detail output displays the following information:
  • Configured admin state
  • Inline power state
  • MIB detect status
  • Label
  • Operator limit
  • PD class
  • Max allowed power
  • Measured power
  • Line voltage
  • Current
  • Fault status
  • Detailed status
  • Priority
* (CIT_32.1.1.6) 5720-24MW-SwitchEngine.1 # show inline-power perpetual 
Perpetual PoE
-------------
Disabled 
To display PoE fast information by port, run the show inline-power fast ports {port_list} command. This command displays the following information:
  • Port status (enabled/disabled)
  • Operator limits
  • Priority
  • Detection method
* (CIT_32.1.0.383) 5720-24MW-SwitchEngine.2 # sh inline-power fast
State   Enable     Disconnect        Last Fast Boot Status    
-----   --------   ---------------   -------------------------
HW      Disabled   Deny-port         Succeeded
Cfg     Disabled   Deny-port      

State: (HW) Hardware state per-slot, (Cfg) Configured state per-slot.
Fast Boot Status:
  Succeeded - Fast PoE boot succeeded and configuration matches.
  Disabled  - Fast PoE was disabled in hardware at boot time.
  Mismatch  - Fast PoE booted but the configuration in hardware
              did not match the configuration file.
  Failed    - Fast PoE boot failed and PoE was reset.
* (CIT_32.1.0.383) 5720-24MW-SwitchEngine.3