Backbone Area (Area

Any OSPFv3 network that contains more than one area is required to have an area configured as area, also called the backbone.

All areas in an AS must be connected to the backbone. When designing networks, you should start with area and then expand into other areas.



Area exists by default and cannot be deleted or changed.

The backbone allows summary information to be exchanged between area border routers (ABRs). Every ABR hears the area summaries from all other ABRs. The ABR then forms a picture of the distance to all networks outside of its area by examining the collected advertisements and adding in the backbone distance to each advertising router.

When a VLAN is configured to run OSPFv3, you must configure the area for the VLAN.

If you want to configure the VLAN to be part of a different OSPFv3 area, use the following command:

configure ospfv3 vlan vlan-name area area-identifier

If this is the first instance of the OSPFv3 area being used, you must create the area first using the following command:

create ospfv3 area area_identifier