Refreshing Network-Zones

To refresh a specific network-zone, or all the network-zones, enter the following command:

refresh access-list network-zone [zone_name | all]

Here is an example:

Switch# refresh access-list network-zone zone1
Note

Note

When you issue the command to refresh a network-zone, or all network-zones, it can take a long time to clear the CLI because each individual policy must be converted before it is refreshed. The command succeeds, or fails, only after it receives a success response for all policy refresh, or when a first refresh failure is received from the hardware.

If the refresh fails for a specific zone, the following error message is printed on the console.

Switch# refresh access-list network-zone zone1
Error: Refresh failed for network-zone "zone1".