Search

Finding the Inactive Partition

A switch can store up to two core images: an active and inactive. When downloading a new image, you must select on which partition to install the new image. You must install the software image to the inactive partition, and must specify that partition while downloading the image to the switch.

To find the inactive partition:

  1. From the CLI, enter the command show switch (or show slot detail on SummitStack). 
    # show switch
SysName:          XXXXXXX
SysLocation:
SysContact:       support@extremenetworks.com, +1 888 257 3000
System MAC:       00:04:96:51:FE:E2
System Type:      XXXXXXX

SysHealth check:  Enabled (Normal)
Recovery Mode:    All
System Watchdog:  Enabled 

Current Time:     Thu Sep  4 00:57:18 2014
Timezone:         [Auto DST Disabled] GMT Offset: 0 minutes, name is UTC.
Boot Time:        Wed Sep  3 20:07:11 2014
Boot Count:       402
Next Reboot:      None scheduled
System UpTime:    4 hours 50 minutes 7 seconds 

Current State:    OPERATIONAL
Image Selected:   primary
Image Booted:     primary
Primary ver:      15.7.1.4
Secondary ver:    15.7.1.5 

Config Selected:  ssh-privatekey.cfg
Config Booted:    ssh-privatekey.cfg 
                  ssh-privatekey.cfg Created by ExtremeXOS version 15.7.1.5                  
            219131 bytes saved on Mon Jul 14 23:03:08 2014
  2. Locate the Image Booted: line. If it indicates primary, you will know to install the images on the secondary partition. If it indicates secondary, you will know to install the images on the primary partition.
    For help with versions and image filenames, refer to the following:
When you know the inactive partition, proceed to Installing a Core Image.
9037560-00 Rev AA