range

Specifies a range of addresses for routes matching address/mask for OSPF summarization

Supported in the following platforms:

Access Points — AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i/h, AP7522, AP7532, AP7562, AP7612, AP7632, AP7662, AP8432, AP8533

Syntax

range <IP/M>

Parameters

range <IP/M>


<IP/M>	Specifies the routes matching address/mask for summarization. Note: This command is applicable for a ABR (Area Border Router) only.

Examples

nx9500-6C8809(config-profile default-nx5500-router-ospf-area-0.0.0.1)#range 172.16.10.0/24

nx9500-6C8809(config-profile default-nx5500-router-ospf-area-0.0.0.1)#show context
  area 0.0.0.1
   authentication simple-password
   range 172.16.10.0/24
   area-type stub default-cost 1
nx9500-6C8809(config-profile default-nx5500-router-ospf-area-0.0.0.1)#

Related Commands


no (area-config-mode-command)	Removes the configured network IP range