diag

Profile Config Commands

Enables looped packet logging. When enabled, devices, using this profile, start logging looped packets to a separate queue. This option is disabled by default.

Looped packet logging can also be enabled in the device configuration context.

Note

To view logged looped packets, execute the service > show > diag > pkts command. For more information, see service.

Supported on the following devices:

• Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
• Service Platforms: NX5500, NX7500, NX9500, NX9600
• Virtual Platforms: CX9000, VX9000

Syntax

Parameters

diag pkts

Related Commands