fallback

Enables fallback to destination-based routing. This option is enabled by default. To disable fallback, use the no → fallback command.

The action taken for packets satisfying the match criteria is determined by the mark (action) clauses. If no action is defined, the default is to fallback to destination-based routing.

Note

Note

If no mark clause is configured and fallback to destination-based routing is disabled, then the packet is dropped.

Supported on the following devices:

Syntax

fallback

Parameters

None

Examples

nx9500-6C8809(config-routing-policy-testpolicy-route-map-1)#fallback
nx9500-6C8809(config-routing-policy-testpolicy-route-map-1)#

Related Commands

no (route-map-config-mode-command) Disables fallback to destination-based routing if no next hop is configured or are unreachable