radius-vlan-assignment

Enables assignment of a RADIUS VLAN for this captive portal

When enabled, if the RADIUS server as part of the authentication process returns a client‘s VLAN-ID in a RADIUS access-accept packet, then all client traffic is forwarded on the post authentication VLAN. If disabled, the RADIUS server‘s VLAN assignment is ignored and the VLAN configuration defined within the WLAN configuration is used instead. This feature is disabled by default.

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

radius-vlan-assignment

Parameters

None

Example

nx9500-229D58(config-captive-portal-test)#radius-vlan-assignment

nx9500-229D58(config-captive-portal-test)#show context
captive-portal test
 post-authentication-vlan 1
 radius-vlan-assignment
nx9500-229D58(config-captive-portal-test)#

Related Commands


no	Disables assignment of a RADIUS VLAN for this captive portal