meshpoint-device

Profile Config Commands

Configures meshpoint device parameters. This feature is configurable in the profile and device configuration modes.

Supported on the following devices:

Syntax

meshpoint-device <MESHPOINT-NAME>

Parameters

meshpoint-device <MESHPOINT-NAME>
meshpoint-device <MESHPOINT-NAME> Configures meshpoint device parameters
  • <MESHPOINT-NAME> – Specify meshpoint name.

Usage Guidelines

For VMM (Vehicular Mounted Modem) access points or other mobile devices, set the path selection method as mobile-snr-leaf in the config-meshpoint-device mode. For more information, see path-method (meshpoint-device-config).

nx9500-6C8809(config-profile-TestAP8533)#meshpoint-device test

nx9500-6C8809(config-profile-TestAP8533-meshpoint-test)#?
Mesh Point Device Mode commands:
  acs          Configure auto channel selection parameters
  exclude      Exclude neighboring Mesh Devices
  hysteresis   Configure path selection SNR hysteresis values
  monitor      Event Monitoring
  no           Negate a command or set its defaults
  path-method  Path selection method used to find a root node
  preferred    Configure preferred path parameters
  root         Set this meshpoint as root
  root-select  Root selection method parameters

  clrscr       Clears the display screen
  commit       Commit all changes made in this session
  do           Run commands from Exec mode
  end          End current mode and change to EXEC mode
  exit         End current mode and down to previous mode
  help         Description of the interactive help system
  revert       Revert changes
  service      Service Commands
  show         Show running system information
  write        Write running configuration to memory or terminal

nx9500-6C8809(config-profile-TestAP8533-meshpoint-test)#

Related Commands

no Removes a specified meshpoint
Note

Note

For more information on the meshpoint-device configuration parameters, see Meshpoint Policy.