no (l2tpv3-policy-config-mode-command)

Removes this L2TPv3 policy settings or reverts them to default values

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

no [cookie-size|failover-delay|force-l2-path-recovery|hello-interval|
reconnect-attempts|reconnect-interval|retry-attempts|retry-interval|rx-window-size|
tx-window-size]

Parameters

no <PARAMETERS>


no <PARAMETERS>	Negates or reverts L2TPV3 policy settings to default

Examples

The following example shows the l2tpv3 policy ‘L2TPV3Policy1‘ settings before the ‘no‘ commands are executed:

nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#show context
l2tpv3 policy L2TPV3Policy1
 hello-interval 200
 retry-attempts 10
 retry-interval 30
 cookie-size 8
 reconnect-interval 100
 reconnect-attempts 50
nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#

nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#no hello-interval

nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#no reconnect-attempts

nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#no reconnect-interval

nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#no retry-attempts

nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#no retry-interval

nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#no cookie-size

The following example shows the l2tpv3 policy ‘L2TPV3Policy1‘ settings after the ‘no‘ commands are executed:

nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#show context
l2tpv3 policy L2TPV3Policy1
nx9500-6C8809(config-l2tpv3-policy-L2TPV3Policy1)#