payload

Configures payload settings. The payload command sets a numerical index pattern and offset for this WIPS signature. Payload-based signatures detect patterns in the content of the file rather than attributes, such as a hash, allowing them to identify and block altered malware.

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

payload <1-3> pattern <WORD> offset <0-255>

Parameters

payload <1-3> pattern <WORD> offset <0-255>


payload <1-3>	Configures payload settings <1-3> – Set the payload index from 1 - 3.
pattern <WORD>	Specifies the pattern to match: hex or string <WORD> – Set the pattern name.
offset <0-255>	Specifies the payload offset to start the pattern match <0-255> – Set the offset value from 0 - 255.

Examples

nx9500-6C8809(config-test-signature-test)#payload 1 pattern test offset 1

nx9500-6C8809(config-test-signature-test)#show context
 signature test
  bssid 11-22-33-44-55-66
  dst-mac 55-66-77-88-99-00
  frame-type assoc
  filter-ageout 8
  payload 1 pattern test offset 1
nx9500-6C8809(config-test-signature-test)#

Related Commands


no (wips-signature-config-mode-command)	Removes payload index and associated settings