no

Removes or resets this auto IPSec tunnel settings

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

no [groupid|ike-lifetime|ikev2 peer reauth|ip nat crypto]

Parameters

no <PARAMETERS>


no <PARAMETERS>	Removes or resets this auto IPSec tunnel‘s settings based on the parameters passed

Example

The following example shows the Auto IPSec VLAN bridge settings before the ‘no‘ command is executed:

nx9500-6C8809(config-profile-default-ap8533-crypto-auto-ipsec-secure)#show context
 crypto auto-ipsec-secure
  groupid testpassword@123 rsa
nx9500-6C8809(config-profile-default-ap8533-crypto-auto-ipsec-secure)#

nx9500-6C8809(config-profile-default-ap8533-crypto-auto-ipsec-secure)#no groupid

The following example shows the Auto IPSec VLAN bridge settings after the ‘no‘ command is executed:

nx9500-6C8809(config-profile-default-ap8533-crypto-auto-ipsec-secure)#show context
 crypto auto-ipsec-secure
nx9500-6C8809(config-profile-default-ap8533-crypto-auto-ipsec-secure)#