stateful-packet-inspection-12
Enables layer 2 firewall stateful packet inspection. When
enabled, allows stateful packet inspection for RF Domain manager routed interfaces within
the layer 2 firewall. This option is enabled by default.
Supported on the following devices:
- Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502,
AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543,
AP8533.
- Service Platforms:
NX5500, NX7500, NX9500, NX9600
- Virtual Platforms: CX9000, VX9000
Syntax
stateful-packet-inspection-l2
Examples
nx9500-6C8809(config-fw-policy-testFW)#stateful-packet-inspection-l2
Related Commands
| no |
Disables stateful packet inspection in a layer 2
firewall |
