use

Configures a tunnel to use a specified L2TPV3 tunnel policy and specified critical resources

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

use [critical-resource|l2tpv3-policy]

use critical-resource <CRM-NAME1> {<CRM-NAME2>} {<CRM-NAME3>} {<CRM-NAME4>}

use l2tpv3-policy <L2TPV3-POLICY-NAME>

Parameters

use critical-resource <CRM-NAME1> {<CRM-NAME2>} {<CRM-NAME3>} {<CRM-NAME4>}


use critical-resource <CRM-NAME1> {<CRM-NAME2>} {<CRM-NAME3>} {<CRM-NAME4>}	Specifies the critical resource(s) to use with this tunnel <CRM1-NAME> – Specify the first critical resource name (should be existing). <CRM-NAME2/3/4> – Optional. Specify the second/third/fourth critical resource names. Maximum of four critical resources can be monitored. Note: In case of tunnel initiator, L2TPv3 tunnel is established only if the critical resources identified by the <CRM-NAME1>.................. <CRM-NAME4> arguments are available at the time of tunnel establishment. Note: In case of L2TPv3 tunnel termination, all incoming tunnel establishment requests are rejected if the critical resources specified by the <CRM-NAME1>.............. <CRM-NAME4> arguments are not available.

use l2tpv3-policy <L2TPV3-POLICY-NAME>


use l2tpv3-policy <L2TPV3-POLICY-NAME>	Associates a specified L2TPV3 policy with this tunnel <L2TPV3-POLICY-NAME> – Specify the policy name.

Examples

nx9500-6C8809(config-profile default-nx5500-l2tpv3-tunnel-Tunnel1)#use l2tpv3-policy L2TPV3Policy1

nx9500-6C8809(config-profile default-nx5500-l2tpv3-tunnel-Tunnel1)#show context
 l2tpv3 tunnel Tunnel1
  peer 2 hostname tunnel1peer1 udp port 100
  use l2tpv3-policy L2TPV3Policy1
  session tunnel1peer1session1 pseudowire-id 5000 traffic-source vlan 10-20 native-vlan 1
  router-id 2000
  establishment-criteria cluster-master
nx9500-6C8809(config-profile default-nx5500-l2tpv3-tunnel-Tunnel1)#

Related Commands


no	Removes the L2TPV3 policy configured with a tunnel and reverts to the default tunnel policy