routing-policy

Creates a routing policy and enters its configuration mode

Supported on the following devices:

Syntax

routing-policy <ROUTING-POLICY-NAME>

Parameters

routing-policy <ROUTING-POLICY-NAME>
<ROUTING-POLICY-NAME> Specify the role policy name. If the policy does not exist, it is created.

Examples

nx9500-6C8809(config)#routing-policy test
nx9500-6C8809(config-routing-policy-test)#?
Routing Policy Mode commands:
  apply-to-local-packets  Use Policy Based Routing for packets generated by
                          the device
  logging                 Enable logging for this Route Map
  no                      Negate a command or set its defaults
  route-map               Create a Route Map
  use                     Set setting to use

  clrscr                  Clears the display screen
  commit                  Commit all changes made in this session
  do                      Run commands from Exec mode
  end                     End current mode and change to EXEC mode
  exit                    End current mode and down to previous mode
  help                    Description of the interactive help system
  revert                  Revert changes
  service                 Service Commands
  show                    Show running system information
  write                   Write running configuration to memory or terminal

nx9500-6C8809(config-routing-policy-test)#

Related Commands

no Removes an existing routing policy
Note

Note

For more information on Routing Policy commands, see Routing Policy.