l2tpv3

Establishes or brings down a Layer 2 Tunnel Protocol Version 3 (L2TPv3) tunnel

Note

This command and its syntax is common to both the User Executable and Privilege Executable configuration modes.

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

l2tpv3 tunnel [<TUNNEL-NAME>|all]

l2tpv3 tunnel <TUNNEL-NAME> [down|session|up]

l2tpv3 tunnel <TUNNEL-NAME> [down|up] {on <DEVICE-NAME>}

l2tpv3 tunnel <TUNNEL-NAME> session <SESSION-NAME> [down|up] {on <DEVICE-NAME>}

l2tpv3 tunnel all [down|up] {on <DEVICE-NAME>}

l2tpv3 tunnel <TUNNEL-NAME> [down|up] {on <DEVICE-NAME>}


l2tpv3 tunnel	Establishes or brings down L2TPV3 tunnels
<TUNNEL-NAME> [down\|up]	Specifies the tunnel name to establish or bring down down – Brings down the specified tunnel up – Establishes the specified tunnel
on <DEVICE-NAME>	Optional. Establishes or brings down a tunnel on a specified device <DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.

l2tpv3 tunnel <TUNNEL-NAME> session <SESSION-NAME> [down|up] {on <DEVICE-NAME>}


l2tpv3 tunnel	Establishes or brings down L2TPV3 tunnels
<TUNNEL-NAME> [session <SESSION-NAME>] [down\|up]	Establishes or brings down a specified session inside an L2TPV3 tunnel <TUNNEL-NAME> – Specify the tunnel name. session <SESSION-NAME> – Identifies a specific session <SESSION-NAME> – Specify the session name. down – Brings down the session identified by the <SESSION-NAME> keyword up – Establishes the session identified by the <SESSION-NAME> keyword
on <DEVICE-NAME>	Optional. Establishes or brings down a tunnel session on a specified device <DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.

l2tpv3 tunnel all [down|up] {on <DEVICE-NAME>}


l2tpv3 tunnel	Establishes or brings down L2TPV3 tunnel
all [down\|up]	Establishes or brings down all L2TPV3 tunnels down – Brings down all tunnels up – Establishes all tunnels
on <DEVICE-NAME>	Optional. Establishes or brings down all tunnels on a specified device <DEVICE-NAME> – Specify the name of the AP, wireless controller, or service platform.

nx9500-6C8809>l2tpv3 tunnel testTunnel session testSession1 up on ap505-13403

Note

For more information on the L2TPV3 tunnel configuration mode and commands, see L2TPv3 Policy.