aeroscout

Enables Aeroscout multicast packet forwarding. This feature is disabled by default.

Supported in the following platforms:

Access Points — AP3000/X, AP5010, AP310i/e, AP410i/e, AP460i/e, AP505i, AP510i/e, AP560i/h, AP7612, AP7632, AP7662, AP8533

Syntax

aeroscout [forward ip <IP> port <0-65535>|mac <MAC>]

Parameters

aeroscout [forward ip <IP> port <0-65535>|mac <MAC>]


aeroscout	Enables Aeroscout packet forwarding and configures the packet forwarding parameters
forward ip <IP> port <0-65535>	Configures the following Aeroscout locationing engine details: ip – Configures Aeroscout engine‘s IP address <IP> – Specify the Aeroscout engine‘s IP address. When specified, the AP forwards Aeroscout beacons directly to the Aeroscout locationing engine without proxying through the controller or RF Domain manager. port – Configures the port on which the Aeroscout engine is reachable <0-65535> – Specify the port number from 0 - 65535.
mac <MAC>	Configures the multicast MAC address to forward the Aeroscout packets <MAC> – Specify the MAC address in the AA-BB-CC-DD-EE-FF format. The default value is 01-0C-CC-00-00-00.

Example

nx9500-6C8809(config-profile-ProfileTestAP505-if-radio2)#aeroscout forward ip 10.233.84.206 port 22

nx9500-6C8809(config-profile-ProfileTestAP505-if-radio2)#show context
 interface radio2
  aeroscout forward ip 10.233.84.206 port 22
nx9500-6C8809(config-profile-ProfileTestAP505-if-radio2)#

Related Commands


no (radio-interface-config-command)	Disables Aeroscout packet forwarding