bootp (dhcpv4-server-policy-config)

Configures a BOOTP specific configuration. Bootstrap Protocol (BOOTP) requests are used by UNIX diskless workstations to obtain the location of their boot image and IP address within the managed network. A BOOTP configuration server provides this information and also assigns an IP address from a configured pool of IP addresses. By default, all BOOTP requests are forwarded to the BOOTP configuration server by the controller. When enabled, this feature allows controllers, using this DHCP server policy, to ignore BOOTP requests.

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632, AP7662, AP8163, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

bootp ignore

Parameters

bootp ignore


bootp ignore	Enables controllers to ignore BOOTP requests

Examples

nx9500-6C8809(config-dhcp-policy-test)#bootp ignore

nx9500-6C8809(config-dhcp-policy-test)#show context
dhcp-server-policy test
 bootp ignore
nx9500-6C8809(config-dhcp-policy-test)#

Related Commands


no (dhcpv4-server-policy-config)	Disables the ignore BOOTP requests option