radio-share-mode

interface-config-radio-instance

Configures the radio‘s mode of operation as radio share. A radio operating in the radio share mode services clients and also performs sensor functions (defined by the radio‘s ADSP licenses and profiles).

Note

Note

The sensor capabilities of the radio are restricted to the channel and WLANs defined on the radio.

Supported in the following platforms:

Syntax

radio-share-mode [inline|off|promiscuous]

Parameters

radio-share-mode [inline|off|promiscuous]
radio-share-mode Enables sharing of packets, switched by this radio, with the WIPS sensor module. There are two radio-share modes, these are: inline and promiscuous
inline Enables sharing of all WLAN packets (matching the BSSID of the radio) serviced by the radio with the WIPS sensor module.
off Disables radio share (no packets shared with the WIPS sensor module)
promiscuous Enables the promiscuous radio share mode. In this mode the radio is configured to receive all packets on the channel irrespective of whether the destination address is the radio or not, and shares these packets with the WIPS sensor module for analysis (i.e. without filtering based on BSSI).

Example

nx9500-6C8809(config-profile-510TestProfile-if-radio1)#radio-share-mode promiscuous

nx9500-6C8809(config-profile-510TestProfile-if-radio1)#show context
 interface radio1
  power 12
  data-rates b-only
  placement outdoor
  mesh client
  off-channel-scan channel-list 2.4GHz 1
  preamble-short
  guard-interval long
  .........................................................
  non-unicast queue bss 16 50
  antenna-diversity
  max-clients 100
  radio-share-mode promiscuous
  airtime-fairness prefer-ht weight 6
  lock-rf-mode
  extended-range 15
  antenna-downtilt
nx9500-6C8809(config-profile-510TestProfile-if-radio1)#

Related Commands

no (radio-interface-config-command) Resets the radio share mode for this radio to its default