configure

Enters the configuration mode. Use this command to enter the current device's configuration mode, or enable configuration from the terminal.

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

configure {self|terminal}

configure {self|terminal}


self	Optional. Enables the logged-in device's configuration mode
terminal	Optional. Enables configuration from the terminal

ap505-13403B#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
ap505-13403B(config)#

nx9500-6C8809#configure self
Enter configuration commands, one per line.  End with CNTL/Z.
nx9500-6C8809(config-device-B4-C7-99-6C-88-09)#