floor
Device Config Commands
Sets the building floor name representative of the location within the area or building the device (controller, service platform, or access point) is physically deployed. Assigning a building floor name is helpful when grouping devices in RF Domains and profiles, as devices on the same physical building floor may need to share specific configuration parameters in respect to radio transmission and interference requirements specific to that location.
Supported on the following devices:
- Access Points:
AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP7602, AP7612, AP7622, AP7632,
AP7662, AP8163, AP8533.
- Service Platforms:
NX5500, NX7500, NX9500, NX9600
- Virtual Platforms: CX9000, VX9000
floor <FLOOR-NAME> <1-4094>
Parameters
floor <FLOOR-NAME> <1-4094>
| floor <FLOOR-NAME>
<1-4094> |
Sets the building floor name where the device is deployed
- <1-4094> – Sets a numerical floor designation in respect to the floor‘s actual location within a building. Specify a value from 1 - 4094. The default setting is the 1st floor.
|
Example
nx9500-6C8809(config-device-94-9B-2C-13-3E-1C)#floor 5thfloor
nx9500-6C8809(config-device-94-9B-2C-13-3E-1C)#show context
ap505 94-9B-2C-13-3E-1C
use profile default-ap505
use rf-domain default
hostname ap505-133E1C
area RMZEcospace
floor 5thfloor
contact Bob+1-631-738-5200
country-code us
channel-list 2.4GHz 1,2
nx9500-6C8809(config-device-94-9B-2C-13-3E-1C)#
Related Commands
| no |
Removes device‘s location floor name |
