native

gre tunnel

Configures native trunking settings for this GRE tunnel

Supported on the following devices:

Syntax

native [tagged|vlan <1-4094>]

Parameters

native [tagged|vlan <1-4094>]
native tagged Enables native VLAN tagging

The IEEE 802.1Q specification is supported for tagging frames and coordinating VLANs between devices. IEEE 802.1Q adds four bytes to each frame identifying the VLAN ID for upstream devices that the frame belongs. If the upstream Ethernet device does not support IEEE 802.1Q tagging, it does not interpret the tagged frames. When VLAN tagging is required between devices, both devices must support tagging and be configured to accept tagged VLANs. When a frame is tagged, the 12 bit frame VLAN ID is added to the 802.1Q header so upstream Ethernet devices know which VLAN ID the frame belongs to. The device reads the 12 bit VLAN ID and forwards the frame to the appropriate VLAN. When a frame is received with no 802.1Q header, the upstream device classifies the frame using the default or native VLAN assigned to the Trunk port. The native VLAN allows an Ethernet device to associate untagged frames to a VLAN when no 802.1Q frame is included in the frame. This feature is disabled by default.

native vlan <1-4094> Specifies a numerical VLAN ID (1 - 4094) for the native VLAN

The native VLAN allows an Ethernet device to associate untagged frames to a VLAN, when no 802.1q frame is included in the frame. Additionally, the native VLAN is the VLAN untagged traffic is directed over when using a port in trunk mode.

Example

nx9500-6C8809(config-profile testNX9500-gre-tunnel-testGREtunnel)#native tagged

nx9500-6C8809(config-profile testNX9500-gre-tunnel-testGREtunnel)#native vlan 20

nx9500-6C8809(config-profile testNX9500-gre-tunnel-testGREtunnel)#show context
 gre tunnel testGREtunnel
  native vlan 20
  native tagged
  mtu ipv4 1200
  mtu ipv6 1300
  establishment-criteria rf-domain-manager
nx9500-6C8809(config-profile testNX9500-gre-tunnel-testGREtunnel)#

Related Commands

no Removes the GRE tunnel settings based on the parameters passed