meshpoint-qos-policy

Configures a set of parameters that defines the meshpoint QoS policy.
Note

Note

The WiNG 7.1.X release does not support Meshpoint configuration on AP5XX model access points. This feature will be supported in future releases.

Configured on WiNG 7.1.X controller and pushed to the following WiNG 5.9.X APs:

Syntax

meshpoint-qos-policy <MESHPOINT-QOS-POLICY-NAME>

Parameters

meshpoint-qos-policy <MESHPOINT-QOS-POLICY-NAME>
<MESHPOINT-QOS-POLICY-NAME> Specify the meshpoint QoS policy name. If a policy with the specified name does not exist, it is created.

Examples

nx9500-6C8809(config)#meshpoint-qos-policy test
nx9500-6C8809(config-meshpoint-qos-test)#?
Mesh Point QoS Mode commands:
  accelerated-multicast  Configure accelerated multicast streams address and
                         forwarding QoS classification
  no                     Negate a command or set its defaults
  rate-limit             Configure traffic rate-limiting parameters on a
                         per-meshpoint/per-neighbor basis

  clrscr                 Clears the display screen
  commit                 Commit all changes made in this session
  do                     Run commands from Exec mode
  end                    End current mode and change to EXEC mode
  exit                   End current mode and down to previous mode
  help                   Description of the interactive help system
  revert                 Revert changes
  service                Service Commands
  show                   Show running system information
  write                  Write running configuration to memory or terminal

nx9500-6C8809(config-meshpoint-qos-test)#

Related Commands

no Removes an existing meshpoint QoS policy
Note

Note

For more information on Meshpoint QoS policy configuration, see Meshpoint Policy.