check-ra-consistency

Enables checking of consistency in RA values advertised by this router with those advertised by other routers, if any, on the same link. If the values advertised are inconsistent, a conflict is logged.

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

check-ra-consistency

Parameters

None

Examples

nx9500-6C8809(config-ipv6-radv-policy-test)#check-ra-consistency

nx9500-6C8809(config-ipv6-radv-policy-test)#show context
ipv6-router-advertisement-policy test
 advertise mtu
 advertise hop-limit
 check-ra-consistency
nx9500-6C8809(config-ipv6-radv-policy-test)#

Related Commands


no (ipv6-ra-policy-config-commands)	Disables comparison of interface-specific parameters advertised by other routers, within the link, with those advertised with this router