peer

Sets the peer device‘s IP address. This can be set for multiple remote peers. The remote peer can be an IP address.

Supported on the following devices:

Access Points: AP3000/X, AP5010, AP310i/e, AP410i/e, AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
Service Platforms: NX5500, NX7500, NX9500, NX9600
Virtual Platforms: CX9000, VX9000

Syntax

peer <IP>

Parameters

peer <IP>


peer <IP>	Enter the peer device‘s IP address. If not configured, it implies respond to any peer.

Example

nx9500-6C8809(config-profile-default-ap8533-cryptomap-map1#1)#peer 172.16.10.12

nx9500-6C8809(config-profile-default-ap8533-cryptomap-map1#1)#show context
 crypto map map1 1 ipsec-manual
  peer 172.16.10.12
nx9500-6C8809(config-profile-default-ap8533-cryptomap-map1#1)#