configure eaps config-warnings on

configure eaps config-warnings on

Description

Enables the loop protection warning messages displayed when configuring specific EAPS (Extreme Automatic Protection Switching) parameters.

Syntax Description

This command has no arguments or variables.

Default

By default, loop protection warnings are enabled and displayed when configuring specific EAPS parameters.

Usage Guidelines

This is a global EAPS command. You configure the warning message display on a per switch basis, not per EAPS domain.

When configuring the following EAPS parameters, the switch displays loop protection warning messages:
  • Adding EAPS primary or secondary ring ports to a VLAN (Virtual LAN)

  • Deleting a protected VLAN

  • Disabling the global EAPS setting on the switch

  • Disabling an EAPS domain

  • Configuring an EAPS domain as a transit node

  • Unconfiguring EAPS primary or secondary ring ports from an EAPS domain

We recommend that you keep the loop protection warning messages enabled.

Example

The following command enables the loop protection warning messages:

configure eaps config-warnings on

History

This command was first available in ExtremeXOS 11.4.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.