configure policy convergence-endpoint ports

configure policy convergence-endpoint ports [<port_list> | all] [cisco | lldp-med] [enable | disable]

Description

This command enables or disables a Convergence End Point (CEP) detection type on one or more ports.

Syntax Description

port_list Specifies ports to configure for CEP detection.
all Specifies that all ports are configured for CEP detection.
cisco Selects Cisco type of CEP detection.
lldp-med Selects LLDP (Link Layer Discovery Protocol)-MED type of CEP detection.
enable Enables CEP for the provided type.
disable Disables CEP for the provided type.

Default

By default, CEP detection is disabled on all ports for all types.

Usage Guidelines

This feature requires that ONEPolicy is enabled on the switch (see enable policy).

Example

The following example configures CEP detection for Cisco type on port 3:

# configure policy convergence-endpoint ports 3 cisco enable

History

This command was first available in ExtremeXOS 22.2.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.