configure snmp traps batch-delay bfd

configure snmp traps batch-delay bfd none | delay

Description

This command allows you to configure the time during which the set of affected sessions will be collected and a single trap will be set for contiguous session IDs. This means that there is a small delay between event occurence and trap generation. You have the option to disable this optimization delay using the none option.

Syntax Description

snmp Configure SNMP (Simple Network Management Protocol) specific settings.
traps Configure SNMP Trap generation settings.
batch-delay Maximum delay before trap generation in order to combine multiple traps into a single trap.
none Disables trap optimization which results in generation of one trap for status change of each session.
delay Choose delay to balance between number of traps and delay in trap generation. Range is 50 to 65535 ms.

Default

1000 ms.

Usage Guidelines

Use this command to configure the time window during which the set of affected sessions is collected and single trap is set for contiguous sessions IDs.

Example

The following command configures the BFD batch-delay:

configure snmp traps batch-delay bfd 1000

History

This command was first available in ExtremeXOS 15.5.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.