unconfigure sflow collector

unconfigure sflow collector {ipaddress} ipaddress {port udp-port-number} {vr vr_name}

Description

Unconfigures the sFlow collector.

`ipaddress`	Specifies the IP address of the collector to reset.
`udp-port-number`	Specifies the UDP port.
`vr_name`	Specifies which virtual router. Note: User-created VRs are supported only on the platforms listed for this feature in the ExtremeXOS 22.2 Feature License Requirements document.

The following values are the defaults for this command:

This command allows you to reset the specified sFlow collector parameters to the default values.

Both the commands unconfigure ports monitor vlan and unconfigure sflow collector will reset the collector parameters to the default.

The following command removes the collector at IP address 192.168.57.1:

unconfigure sflow collector ipaddress 192.168.57.

This command was first available in ExtremeXOS 11.0.

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.

Published August 2017prev | next