Sets the power limit allowed for PDs connected to the specified ports.
| milliwatts | An integer specifying the maximum allowed power in milliwatts. |
| port_list | Specifies one or more ports or slots and ports. |
This command sets the power limit that a PD can draw on the specified ports. For PoE, the range is 3000 to 16800mW and the default value is 15400 mW. For PoE+, the range is 3,000 to 30,000 mW and the default value is 30000 mW. For PoE++, the range is 3,000 mW to 60,000 mW and the default value is 60,000 mW.
If the measured power for a specified port exceeds the port‘s operator limit, the power is withdrawn from that port and the port moves into a fault state.
If you try to set an operator-limit outside the accepted range, the system returns the following error message:
Error: Invalid operator-limit value. Must be in the range of 3000-16800 mW
The following command sets the limit for legacy PDs on ports 3 – 6 of slot 5 on a SummitStack to 10000 mW:
configure inline-power operator-limit 10000 ports 5:3-5:6
This command was first available in ExtremeXOS 11.1.
PoE+ was added in ExtremeXOS 12.5.
PoE++ was added in ExtremeXOS 22.2.
This command is available on:
Print
this page
Email this topic
Feedback
View PDF
Download EPUB