configure erps dynamic-state

configure erps ring-name dynamic-state [force-switch | manual-switch | clear] port slot:port

Description

Configure or clear force-switch or manual-switch for the ERPS (Ethernet Ring Protection Switching) ring/sub-ring.

Syntax Description

dynamic-state Configure force/manual/clear switch on the active ERPS ring.
force-switch Force-switch operation.
manual-switch Manual-switch operation.
clear Clears force-switch/manual-switch.

Default

N/A.

Usage Guidelines

Use this command to configure or clear force-switch or manual-switch for the ERPS ring/sub-ring.

Note

Note

In non-revertive mode, in the "Pending" state, you can use the clear option of this command to return to the "Idle" state where the blocked link is manually reverted to the Ring Protection Link (RPL).

Example

The following command clears force-switch and manual-switch on an ERPS ring named "ring1":

configure erps ring1 dynamic-state clear

History

This command was first available in ExtremeXOS 15.1.

Platform Availability

This command is available on the Summit X450-G2, X460-G2, X670-G2, X770, and ExtremeSwitching X440-G2, X620, X690, X870 series switches.