configure erps timer hold-off

configure {erps} ring-name timer hold-off [ default | milliseconds ]

Description

Configure a hold-off timer to control when a signal fault is relayed.

`ring-name`	Alphanumeric string that identifies the ERPS (Ethernet Ring Protection Switching) ring.
default	The default value, 0 milliseconds.
`milliseconds`	The interval for the hold-off time in milliseconds, with a range of 0 to 10000.

The default is 0 milliseconds.

Use this command to configure a hold-off timer to control when a signal fault is relayed.

The following command sets the hold-off timer to 1000 milliseconds for an ERPS ring named “ring1”:

configure erps ring1 timer hold-off 1000

This command was first available in ExtremeXOS 15.1.

This command is available on all platforms supported in 12.6 and forward that are running ExtremeXOS.

Published August 2017prev | next